The MachinistPost Blog

Drill reconditioning, machining technique, shop management — by machinists, for machinists.

All Posts Technique Business Equipment Materials Troubleshooting
115 posts · TECHNIQUE  ·  Page 5 of 5
TECHNIQUE
Drill Bit Sizes: Complete Guide
Fractional, number, letter, and metric drill sizes explained with charts and practical selection guidance.
May 1, 2025
Read Article →
TECHNIQUE
Drill Bit Reconditioning vs Resharpening
The difference between basic resharpening and full reconditioning, and when each is the right choice.
April 27, 2025
Read Article →
TECHNIQUE
Drill Bit Point Geometry
How point angle, lip relief, and chisel edge geometry affect drilling performance and tool life.
April 25, 2025
Read Article →
TECHNIQUE
Drill Bit Geometry Field Guide
A practical field reference for identifying, evaluating, and selecting drill geometries on the shop floor.
April 21, 2025
Read Article →
TECHNIQUE
Drill Bit Anatomy Guide
A complete labeled breakdown of every part of a twist drill and what each feature does.
April 13, 2025
Read Article →
TECHNIQUE
Cutting Speed Myths: Faster Is Not Better
Debunking the belief that higher spindle speed always means faster production and better results.
April 11, 2025
Read Article →
TECHNIQUE
Cutting Fluids Guide For Drilling
Everything a machinist needs to know about cutting fluid selection, dilution, and application for drilling.
April 9, 2025
Read Article →
TECHNIQUE
Cutting Fluids For HSS Drill Bits
A focused guide to choosing and applying cutting fluids specifically formulated for HSS drill performance.
April 7, 2025
Read Article →
TECHNIQUE
Cutting Fluids vs Dry Drilling: A Guide
When to use cutting fluid and when dry drilling is actually the better call for your material.
April 5, 2025
Read Article →
TECHNIQUE
Cutting Fluid For HSS Drill Bits
Which cutting fluids work best with HSS drills and how to apply them for maximum tool life.
April 3, 2025
Read Article →
TECHNIQUE
Countersinking And Counterboring: The Drill Bit Connection
How your pilot drill geometry and condition directly impact countersink and counterbore quality.
April 1, 2025
Read Article →
TECHNIQUE
Countersinking And Counterboring Best Practices
Best practices for countersinking and counterboring that produce clean, accurate seating surfaces.
March 30, 2025
Read Article →
TECHNIQUE
Countersink Geometry: 82 vs 90 vs 100 Degree
When to use 82-, 90-, and 100-degree countersinks and how angle affects fit and finish.
March 28, 2025
Read Article →
TECHNIQUE
Coolant Concentration And Drill Life Correlation
Data-backed look at how varying coolant mix ratios correlates with measurable changes in drill longevity.
March 20, 2025
Read Article →
TECHNIQUE
Coolant Concentration And Drill Life
How coolant concentration ratios directly affect HSS drill edge life and hole quality.
March 18, 2025
Read Article →
TECHNIQUE
Chip Load Drilling Calculation
How to calculate chip load for drilling and why it matters more than spindle speed alone.
March 4, 2025
Read Article →
TECHNIQUE
Chip Evacuation In Deep Hole Drilling
How chip packing kills tools in deep-hole work and the strategies that keep flutes clear.
March 2, 2025
Read Article →
TECHNIQUE
Bench Grinder Resharpening: What You Need To Know
The pros, limits, and geometry pitfalls of sharpening HSS drills on a bench grinder.
February 16, 2025
Read Article →
TECHNIQUE
5 Common Drill Selection Mistakes
Five costly drill selection errors that machinists make and how to avoid them.
February 4, 2025
Read Article →
← Prev 12345